Grey Rubber Silicone Polishers. Medium grit
These Grey Rubber Polishing Burrs made by EVE in Germany, are a medium grit abrasive, superb for pre-polishing metals, zirconia, ceramic, natural and synthetic nails and for smoothing in glass engraving.
Use on materials such as glass, enamel, non-ferrous metals such as platinum, gold, titanium and silver and for use on steel, acrylics and resin.
Also to be used as part of the 3-step polishing system with the Green, Coarse (GRP3) and Yellow, Fine (YRP3) Rubber Silicone Polishers for pre-polishing, smoothing and high lustre polishing.
All burrs are mounted on a 2.35mm (3/32") steel shank. The wheel polisher is unmounted and will require a Screw Mandrel. Recommended speed of between 5,000 - 7,000 rpm. Do not exceed 15,000rpm.
Read on for further detailed information and technical specifications.
For further shapes please take a look at the Dark Grey #600 range on this page: EVEFLEX TECHNIK Mounted Rubber Polishing Burrs and the Dark Grey #600 polisher on this page: EVEFLEX TECHNIK Unmounted Rubber Polishers
Use these grey rubber polishers to smooth out the roughness on metals, or for smoothing and shading when glass engraving after pre-smoothing with an Arkansas Stone Burr.
These are high-quality dental rubber abrasives which are mounted on a 2.35mm (3/32") shank. They will be a nice addition to your tool set for working on jewellery making, glass engraving and craft projects for smoothing and polishing metals, enamels, glass, plastics and acrylics.
Can be used on non-ferrous metals such as chrome, titanium, platinum, gold and silver. Plus steel and stainless steel, resin, enamel, acrylics and glass
- Produces a slight lustre
- For use with a hand-held drill, micro motor or pendant drill
- Use Dry
- Begin with slow speed, do not exceed 15,000RPM
- Mounted on a 2.35mm Shank (3/32")
Tip: These are abrasives so be careful to use them within the lines of your design if you're using them in glass or gemstone engraving to avoid marking the surrounding area.
“The large fat grey rubber polisher (Dome shape) is what I have used for many years and is great not only for shading but also on its own on clear glass for creating a “hue”. The Bullet shaped one is softer and is also good for shading and is a little gentler. Both should preferably be used dry and not necessarily at any significant speed. Used on a very rough surface they will wear away fast so if an area of harsh engraving needs softening, preferably use a soft stone to smooth a bit before the rubber. Great on sandblasted areas to create a darker tone” - Lesley Pyke. Lesley Pyke Ltd Glass Engraving
EVE TECHNIK Silicon Carbide mounted burrs on a 2.35mm shank. Medium grit.
- Bullet: Diameter: 10mm, Length: 24mm
- Dome: Diameter: 15mm, Length: 17mm
- Flame: Diameter: 10mm, Length: 20mm
- Small Flame: Diameter: 5.5mm, Length: 16mm
Unmounted EVE Silicon Carbide wheel. Medium grit.
- Wheel knife edged - tapered at the edges: Diameter: 22mm, Depth: 3mm