Double Ended Pin Vice
This double ended pin vice is a useful tool when you want to do something by hand that may require a more precise application.
Hold it as you would a pen for hand carving and engraving on glass, stone or wood with a diamond ball burr. Use it for bead reaming with a diamond point burr, hold cup burrs for rounding off the ends of wires. Use it to stipple engrave on glass, or create fine hair lines or fur with a diamond point bur. Ideal for holding many items such as drill bits, burrs, cutting broaches, taps, wires, screws and winding stems.
Each end has a collet. Unscrew so that the teeth inside loosen and then place your drill, screw, reamer or burr inside and re-tighten. Two collets, one holds up to 1.40mm and the other end 1.30mm - 2.80mm
When you don't want to use an electric drill, or are perhaps unable to use a drill due to health and safety issues, these little pin vices will do the trick.
Double ended pin vice with hollow nickel plated handle. 2 knurled round heads and 2 steel chucks.
- Length: 110mm
Questions & Answers
Ask a question using the form below
Other questions and our answers
What is the smallest drill size that the pin vice will hold?
There are two collets, one holds from 0 up to 1.40mm and the other end 1.30mm - 2.80mm.