
Diamond Point Burrs. Set of 5 Assorted Sizes
Set of 5 Diamond Point Burrs, 1 of each of the following sizes:
0.6mm, 0.8mm, 1.5mm, 2.0mm, 2.5mm
Our Diamond Coated Point Burs which are often referred to as 'Rats Tails' will give very fine line engraving on glass, stone, shell, porcelain, ceramic and hard woods. Perfect for engraving fine lines, hair or fur and ideal for using as a bead reamer for enlarging holes in beads and pearls.
Mounted on a 2.35mm (3/32") shank these are suitable for your use in your rotary tool such as a Dremel, Micro Motor, pendant motor or flexible shaft.
Always wear sufficient safety goggles and face mask and be careful to not exceed a drill speed of 12,000rpm and use very little to no pressure.
If you would like to order these sizes individually, please click here.
Technical
Diamond grit is precisely electroplated onto a 2.35mm steel shank
- Diameter: 0.6mm
- Overall length: 41.5mm
- Diameter: 0.8mm
- Overall length: 44.5mm
- Diameter: 1.5mm
- Overall length: 41.5mm
- Diameter: 2.0mm
- Overall length: 46mm
- Diameter: 2.5mm
- Overall length: 44.5mm