Diamond Cone Burrs
Choose sizes from 3mm - 10mm
These Diamond Coated Cone Burrs are perfect for engraving, carving and sculpting in stone, glass, ceramic, porcelain and hard wood. Use in your pendant drill, rotary hand piece, hobby drill, engraver, micro motor or die grinder. Use with plenty of cold water, wearing protective safety goggles and face mask. Use with little pressure and do not exceed a drill speed of 12,000RPM.
- 3mm x 15mm, 3mm shank, 150 # (Medium)
- 4mm x 15mm, 2.35mm shank, 150 # (Medium)
- 5mm x 20mm, 5mm shank, 120 # (Coarse-Medium)
- 6mm x 20mm, 6mm shank, 120 # (Coarse-Medium)
- 8mm x 20mm, 6mm shank, 80 # (Coarse)
- 10mm x 25mm, 6mm shank, 80 # (Coarse)
Helpful Note: If you are looking for a very fine point, you might like to try our Diamond Point Burs (These come in sizes as small as 0.6mm, 0.8mm...) Or for bevel edges to holes, try our Diamond Countersink Burrs.
Technical
Diamond grit is precisely electroplated onto a steel shank
Diameter: 3mm at base, tapering to a point
- Diamond coated length: 15mm
- Overall length: 50mm
- Shank: 3mm
- Grit 150
Diameter: 4mm at base, tapering to a point
- Diamond coated length: 15mm
- Overall length: 42mm
- Shank: 2.35mm
- Grit 150
Diameter: 5mm at base, tapering to a point
- Diamond coated length: 20mm
- Overall length: 60mm
- Shank: 5mm
- Grit 120
Diameter: 6mm at base, tapering to a point
- Diamond coated length: 20mm
- Overall length: 60mm
- Shank: 6mm
- Grit 120
Diameter: 8mm at base, tapering to a point
- Diamond coated length: 20mm
- Overall length: 62mm
- Shank: 6mm
- Grit 80
Diameter: 10mm 80# (Coarse) at base, tapering to a point
- Diamond coated length: 25mm
- Overall length: 80mm
- Shank: 6mm
- Grit 80
Questions & Answers
Ask a question using the form below
Other questions and our answers
Would these work with a dremel 4300? Thank you for your time.
lisa
Yes, so long as you have an adjustable chuck on the 4300, otherwise you will need the Dremel Multi Chuck. Choose the diamond burrs with either a 2.35mm or 3mm shank.
